• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
INSTALLATION - TM-9-6115-660-13P_143
Figure 4-26. Rear Leveling-Support Jack Replacement; 1 Ton Trailer.

TM-9-6115-660-13P Power Plant Diesel Engine Driven 1-Ton Trailer Mounted (With Racks) 3Kw 60 Hz AN/MJQ-42 Manual
Page Navigation
  112    113    114    115    116  117  118    119    120    121    122  
TM  9-6115-660-13&P 4-26 1 TON TRAILER REAR LEVELING-SUPPORT JACK MAINTENANCE. This task covers: a. Removal c.  Installation b.  Repair INITIAL  SETUP Tools Equipment   Conditions Tool  Kit,  General  Mechanic’s Reference (item 1, appendix B) Jack Stand (item 2, appendix B) Trailer handbrakes set and front support Vise  (item  2,  appendix  B) leg/landing leg lowered; paragraph 2-3.2.1. Materials/Parts Pin,  Cotter Nut,  Self-locking, Pin,  Spring Both generator sets shut down; paragraph 2-5.3.3 General  Purpose Fitting,  Lubrication  (if  needed) Grease,  GAA  (item  2,  Appendix  E) REMOVAL WARNING 1. 2. 3. 4. 5. 6. 7. Before removing trailer leveling-support jack, support rear of trailer with jack stands. Failure to observe this warning can cause severe personal injury or death. Support rear of trailer with jack stands. Turn leg base (11, figure 4-26) to take weight off leg prop. Remove either one of two cotter pins (16 or 6) from pivot shaft (15) and discard. Hold leg base (11) steady and remove pivot shaft (15) with remaining cotter pin (16 or 6) in place. Lift leg base (11) slightly to take weight off retaining pin (10) and  remove  retaining  pin  (10).  Move  leg base (11) and attached parts out of bracket (7). Remove two self-locking nuts (4), four flat washers (5 and 8), Remove self-locking nut (3), two flat washers (2 and 14), and trailer chassis (1). and two cap screws (9). cap  screw  (13).  Remove  bracket  (7)  from 4-52







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.