TM 9-6115-660-13&P
REPAIR
NOTE
Repair is limited to replacement of deck covering (19). Refer to figure G-6, appendix G.
INSTALLATION
1.
2.
3.
4.
5.
6.
7.
8.
Position fender (7) on trailer chassis and loosely install five cap screws (1), ten flat washers (2), and
five self-locking nuts (3).
Install and tighten ten cap screws (6), twenty flat washers (4), and ten self-locking nuts (5).
Tighten five self-locking nuts (3).
NOTE
If new fender(s) are being installed, fire extinguisher bracket, data plate, ground stud, and
reflectors removed during removal procedures must be installed. If replacing roadside
fender, perform steps 4, 5, and 6. If not, proceed to step 8. If replacing curbside fender,
perform steps 6 and 7.
Install fire extinguisher bracket (paragraph 4-20).
Install ground stud (18), two internal tooth lock washers
data plate (17).
Install reflectors (paragraph 4-22).
Install data plates (paragraph 4-22).
16), lock washers (15), nuts (14), and ground
InstalI flat washer (13), ground wire (12), flat washer (11), nut (10), two flat washers (9), and wing
nut (8).
4-48