• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
4-15 SYNCHRONIZING  LIGHT  MAINTENANCE
4-16  TOGGLE  SWITCH  MAINTENANCE. - TM-9-6115-660-13P_124

TM-9-6115-660-13P Power Plant Diesel Engine Driven 1-Ton Trailer Mounted (With Racks) 3Kw 60 Hz AN/MJQ-42 Manual
Page Navigation
  91    92    93    94    95  96  97    98    99    100    101  
TM  9-6115-660-13&P TEST Remove lens (1, figure 4-15) and bulb (2) and measure for continuity between terminals (8). If continuity exists, replace lamp housing. REMOVAL NOTE The switch box has three synchronizing lights. the same for each synchronizing lights. Replacement  procedures  are 1. Cut and remove insulation sleeving (7) from  both leads  (6). 2. Tag leads (6) and unsolder. 3.  Remove  mounting  nut  (12),  internal  tooth  lock  washer  (11),  and  housing  body  (5). INSTALLATION 1. 2. 3. 4. 5. 6. 7. 8. Position rubber gaskets (3 and 9) against mounting collar (4). If necessary, turn mounting collar (4) until proper amount of threads are exposed for installation of lens (1). Insert housing body (5) through opening in switch box cover (10). Place internal tooth lock washer (11) on housing body (5). Install mounting nut (12) on housing body (5). Tighten mounting nut (12) so that rubber gasket (9) seats firmly against switch  box (10). Install insulation sleeving (7) on each wire (6). Solder tagged wires (6) to housing terminals (8). Install lamp (2) into housing body (5). Make sure that rubber gasket (3) is in place against mounting collar (4) and install lens (1) on housing body (5). 4-31







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.