• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
Figure 4-12. Disconnect Power Cable From Switch Box Terminals.
2. Insert terminal lug - TM-9-6115-660-13P_116

TM-9-6115-660-13P Power Plant Diesel Engine Driven 1-Ton Trailer Mounted (With Racks) 3Kw 60 Hz AN/MJQ-42 Manual
Page Navigation
  83    84    85    86    87  88  89    90    91    92    93  
b. c. TM   9-6115-660-13&P Pull power cable (1 or 2) through stuffing tube until ends of power cable are free of stuffing tube body (11). Remove washer (9), seal (10), and stuffing tube compression nut (8) from power cable (1 or 2). Place items back on stuffing tube and tighten. 3.  Disconnect  power  cable  from  switch  box. a. b. c. d. e. f. g. h. i. j. k. l. Release clamping catches (11, figure 4-10) and open switch box cover (1). Remove two screws (2) and lock washers (3) from contactor terminal shield (4) of contactor associated with power cable being removed. Remove contactor terminal shield (4). Remove nuts (5), lock washers (6), and flat washers (7) from contactor terminals (9). Lift terminal leads (8) from contactor terminals (9). Remove only the terminal leads associated with electrical  leads of  power  cable  being  removed.  If  necessary to remove  other  terminal  leads  to  access those for power cable being disconnected, reinstall other terminal leads onto contactor terminals (9). Install flat washers (7), lock washers (6), and terminal nuts (5) on contactor terminals (9). Remove hex nuts (6, figure 4-12) and internal tooth washers (7) from ground and L0 terminals (9) of switch  box. Remove  only  the  wire  associated  with  the  power  cable  being  replaced.  If  necessary  to  remove  other terminal leads to access those for power cable, reinstall other terminal leads on terminal (9). Place internal tooth washers (7) over the end of terminals (9) and loosely install the hex nuts (6). Remove stuffing tube compression nut (10) from stuffing tube body (13). Pull power cable (3 or 4) through stuffing tube until ends of power cable are free of stuffing tube body (13). Remove washer (11), seal (12), and stuffing tube compression nut (10) from power  cable (3 or 4). Place items back on stuffing tube and tighten. 4.  Remove  power  cable  from  clamps. a. Remove self-locking nuts (6, figure 4-11), screws (3), and flat washers (4) securing clamps (5) to trailer.  Remove  cable  (3  or  4). b.  Remove  clamps  (5)  off  power  cable  (3  or  4). INSTALLATION 1.  Install  stuffing  tube  compression  nut  (10,  figure  4-12),  washer  (11),  and  seal  (12)  on  end  of  power cable (3 or 4) having leads with terminal lugs. 4-23







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.