• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
Figure 4-2.  Installation of Ground Wire.
Section IV.  UNIT PREVENTIVE MAINTENANCE CHECKS AND SERVICES - TM-9-6115-660-13P_102

TM-9-6115-660-13P Power Plant Diesel Engine Driven 1-Ton Trailer Mounted (With Racks) 3Kw 60 Hz AN/MJQ-42 Manual
Page Navigation
  69    70    71    72    73  74  75    76    77    78    79  
TM 9-6115-660-13&P Section III.  UNIT LUBRICATION 4-7 POWER PLANT/POWER UNIT LUBRICATION. Detailed instructions for lubrication of major components of the power plants/power units are contained in the applicable generator set Lubrication Orders (LOs) and trailer TMs.  The following paragraphs identify the applicable references and contain lubrication instructions that are not included in the references. 4-7.1 Generator  Set  Lubrication.    Refer  to  LO  9-6115-642-12  for  generator  set  and  engine  lubrication  instructions. See Appendix E for expendable supplies and materials needed for lubrication. 4-7.2 Trailer  Assembly  Lubrication.    Refer  to  TM  9-2330-202-14&P  for  Power  Units  PU-798  and  PU-799  trailer chassis  lubrication  instructions,  TM  9-2330-392-14&P  for  Power  Units  PU-798A  and  PU-799A  trailer  chassis  lubrication instructions,   and   TM   9-2330-213-14&P   for   Power   Plants    AN/MJQ-37    and    AN/MJQ-38    trailer    chassis    lubrication instructions.  See Appendix E for expendable supplies and materials needed for lubrication. 4-7.3 Rear Leveling-Support Jack Lubrication.  The rear leveling-support jack is a modification to the standard 1 1/2 ton trailer chassis, the standard 1 ton trailer chassis, and the high mobility trailer chassis.  Lubrication of this rear leveling- support jack is not covered in the trailer TMs.  See figure 4-3 and lubricate the rear leveling-support jack semiannually, as follows: WARNING Dry   cleaning   solvent   used   to   clean   parts   is   potentially   dangerous   to   personnel   and property.  Clean parts in a well-ventilated area.  Avoid inhalation of solvent fumes.  Wear goggles and rubber gloves to protect eyes and skin.  Wash exposed skin thoroughly.  Do not smoke or use near open flame or excessive heat.  Failure to observe this precaution can cause injury to personnel or damage to equipment. a. Clean the lubrication fitting (1) with dry cleaning solvent.  Expendable supplies and materials needed for lubrication are listed in Appendix E. Figure 4-3.  Rear Leveling-Support Jack Lubrication Points. b. Inject sufficient GAA grease into lubrication fitting (1) to lubricate screw threads (3) inside leg base (4). c. Apply OE lubricating oil to both ends of rear leveling-support jack pivot shaft (2). Change 2   4-9







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.