• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
Figure 3-152. Skid Base Assembly, Exploded View
Section Il. OPERATING TESTS

TM-9-6115-464-34 Generator Set Diesel Engine Driven Tactical Skid Mtd 15 Kw 3 Phase 4 Wire 120/208 and 240/416 Volts Manual
Page Navigation
  352    353    354    355    356  357  358    359    360    361    362  
ARMY TM 9-6115-464-34 AIR FORCE TO 35C2-445-2 NAVY  NAVFAC  P-8-624-34 CHAPTER 4 GENERATOR SET TESTS AFTER OVERHAUL REPAIR INSTRUCTIONS Section I. INSPECTION 4-1.  GENERAL. a. The activity performing the repair or overhaul is responsible for the performance of all applicable tests and inspections specified herein. Activities performing maintenance on any portion of the generator set must perform those tests and inspections required by the applicable component or system repair instruction. b. A thorough inspection of the generator set shall be conducted to insure that workmanship and materials are  satisfactory. c. The inspection shall be conducted each time the generator set is overhauled or rebuilt. 4-2. HOUSING AND FRAME INSPECTION. a. Check that lifting eyes are installed and firmly secured. b. Check that drain holes are open to prevent moisture accumulation. c. Insure that exposed parts are properly treated to resist corrosion. d. Open and close panel doors, engine area doors, and generator area doors to insure proper installation and freedom of motion. e. Inspect movable door gasketing to insure that it is weatherproof. f. Check that all caps and covers are equipped with ties, chains, or other ties to prevent loss. 4-3.  ENGINE  INSPECTION. a. Check mounting bolts of all components and accessories to insure that they are firmly secured. b. Check designation and data plates for legibility. c. Insure that fuel and hydraulic oil lines are protected from damage due to vibration. 4-4.  GENERATOR  INSPECTION. a. Insure that generator leads are properly identified and protected from damage due to vibration. b. Insure that inspection openings are protected by screening or protective plates. c. Check that the engine generator screws are firmly secured. See paragraph 1-10v, for proper torque values. 4-5.  ELECTRICAL  ACCESSORIES  INSPECTION. a. Check all cable and harness assemblies for secure fastenings and protection against chafing and vibration. b. Insure that all cable and harness connectors are firmly secured in their proper place. 4-1







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.