• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
Figure 31 26. Permissive Paralleling Relay Test Circuit
Cleaning. lnspection, and Repair.

TM-9-6115-464-34 Generator Set Diesel Engine Driven Tactical Skid Mtd 15 Kw 3 Phase 4 Wire 120/208 and 240/416 Volts Manual
Page Navigation
  293    294    295    296    297  298  299    300    301    302    303  
ARMY   TM   9-6115-464-34 AIR   FORCE   35C2-3-445-2 NAVY  NAVFAC  P-8-624-34 3-92. STATIC EXCITER AND VOLTAGE REGULATOR ASSEMBLY. a. General. The static exciter and voltage regulator assembly provide excitation and voltage regulation for the generator output voltage and compares it to a reference voltage which is established by the voltage adjust rheostat on the generator set control cubicle. If difference exists, an error signal is sent to the static exciter. Excitation current supplied by the current transformer assembly is altered by the error signal until generator output voltage equals the reference voltage. WARNING Do not attempt to perform maintenance on the static exciter and voltage regulator assembly while the generator set is operating. Severe electrical shock or death may result from failure to observe this warning. b. Removal. (1)  Disconnect electrical connectors to static exciter and voltage regulator assembly. (2)  Remove screws (1, figure 3-130) and Iockwasher (2) to remove static exciter and voltage regulator assembly from generator set. NOTE Disassemble static exciter and voltage regulator assembly only as required to clean, inspect, test and replace components. c. Disassemblv.  . (1) (2) (3) (4) (5) (6) (7) (8) (9) (10) (11) (12) (13) (14) Remove screw (3, figure 3-130), on chassis cover (4) from chassis (68). Remove nut and captive washer assembly (5), flat washer (6), screw (7) to remove heat sink assembly (8). Remove nut and captive washer assembly (9) and screw (10). Remove wire (11), terminal lug (12), and semiconductor (13) as one assembly. Remove semiconductor (14). Remove nut and captive washer assembly (15), screws (16), heat sink (17) and heat sink support (18). Remove nut and captive washer assembly (19), screw (20), and terminal board (21). Remove nut and captive washer assembly (22), screw (23), and transformer (24). Remove nuts (25 and 26), screw (27), capacitor (28), Iockwasher (29) and bracket (30). Remove nut & captive washer assembly (31), terminal (32), and nut& captive washer assembly (33). Remove nut & captive washer assembly (34), screw (35), and transformer (36). Remove screw (37), and voltage regulator assembly (38) from chassis (68). Remove nut & captive washer assembly (39), screw (40), mounting bracket (41) and capacitor C2 (42). Remove nut & captive washer assembly (43), screw (44) and transformer (45). Remove nut & captive washer assembly (46), screw (47), nut& captive washer assembly (48), Washer (49), screw (50), mica washer (51), mounting bracket (52), resistors R1 and R2 (53 and 54). 3-264







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.