• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
Figure 3-116. Overload Protective Device Test Circuit
SPECIAL RELAY ASSEMBLY.

TM-9-6115-464-34 Generator Set Diesel Engine Driven Tactical Skid Mtd 15 Kw 3 Phase 4 Wire 120/208 and 240/416 Volts Manual
Page Navigation
  275    276    277    278    279  280  281    282    283    284    285  
ARMY   TM   9-6115-464-34 AIR   FORCE   35C2-3-445-2 NAVY  NAVFAC  P-8-624-34 (b) (c) (15) (16) Figure  3–117.  Tactical  Relay  Resistor  Assembly  Schematic  Diagram Touch other lead to terminals 3,2, and 1. Ohmmeter should indicate 7.5 ohms in each case. Replace defective components of tactical relay resistor assembly using figure 3-118 as a guide. If the wiring harness has sustained damage and requires repair or rebuild, refer to figure 3-112 for layout, identification, and material requirements and Appendix A for detailed soldering and replacement procedures. d.  Assembly. (1)   Position relay assembly to install Iockwashers (2, figure 3-111) and screws (1). (2)   Connect electrical leads to tactical relay assembly. e. Installation. (1)   Position chassis (26, figure 3-111), to install wiring harness (25), screw& captive washer assembly (24), nut (23), screw & captive washer assembly (22), nut (21), ground screw (20), flatwashers (19), nut & captive washer assembly (18). (2)   Install overload protective device (17), and screw& captive washer assembly (16). (3)    Install short circuit relaly (15), over–voltage relay (14), reverse power relay (13), and screw& captive washer assembly (12). (4)   Install terminal jumper (11), terminal board assembly (10), screw (9), nut & captive washer assembly (8). (5)   Install tactical relay resistor assembly (7), screw (6), nut & captive washer assembly (5). (6)   Install cover(4) with screw (3). (7)   Install Iockwasher (2) and screw (1). 3-246







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.