• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
Asssembly
Installation - TM-9-6115-464-34_130

TM-9-6115-464-34 Generator Set Diesel Engine Driven Tactical Skid Mtd 15 Kw 3 Phase 4 Wire 120/208 and 240/416 Volts Manual
Page Navigation
  106    107    108    109    110  111  112    113    114    115    116  
ARMY TM 9-6115-464-34 AIR FORCE TO 35C2-3-445-2 NAVY  NAVFAC  P-8-624-34 3-33. COOLANT THERMOSTAT AND HOUSING. Refer to the Operator and Unit Maintenance Manual for coolant thermostat and housing maintenance procedures. Section   IV.   MAINTENANCE   OF   ENGINE   LUBRICATION   SYSTEM 3-34.  GENERAL. The engine oil pan serves as a reservoir for lubricating oil. It is equipped with a bayonet type gauge for checking the oil level in the pan. Oil is drawn into a gear type, positive displacement pump through a screen which prevents the entry of coarse abrasives. The oil pump forces the oil through a full flow type oil filter, which removes minute abrasives. From the oil filter the oil flows into the header, a drilled passage in the cylinder block, from which it is distributed to the internal engine components. A pressure transmitter measures oil pressure in the header and transmits it electrically to the oil pressure gauge. Header oil pressure is also measured by a low oil pressure switch which shuts down the engine if oil pressure falls to a dangerously low level. 3-35. LUBRICATION OIL FILTER. Refer to the Operator and Unit Maintenance Manual for lubrication oil filter maintenance procedures. 3-36. OIL LEVEL GAUGE. Refer to the Operator and Unit Maintenance Manual for oil level gauge maintenance procedures. 3-37. OIL PAN ASSEMBLY. a.  Removal. (1) If generator set has winterization kits installed, refer to Operator and Unit Maintenance Manual and remove  kits. (2)  Remove  oil  level  gauge  (1,  figure  3-30). (3)  Remove  elbow  (7)  from  oil  pan. (4) Remove screws (2) and Iockwashers (3) to lower oil pan (4) and remove gaskets (5), and seals (6). Discard seals and gaskets. Refer to paragraph 3-38 and remove oil pump assembly. Remove oil pan. b. Cleaning. Inspection, and Repair. WARNING Solvent, Dry Cleaning P–D-880, Type II is flammable and moderately toxic to skin, eyes and respiratory tract. Eye and skin protection required. Good general ventilation is normally adequate. Failure to observe this warning could cause servere personal injury. (1) Scrape gasket remains from oil pan and cylinder block mating surfaces. WARNING Compressed air used for cleaning and drying purposes can create airborne particles that may enter the eyes. Pressure shall not exceed 30 psig and use only with adequate chip guards and chipping goggles. Failure to observe this warning could cause servere  personal  injury. (2) Clean all parts with dry cleaning solvent (Federal Specification P-D-680) and a stiff bristle brush. Dry  thoroughly  with  filtered,  compressed  air. 3-75







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.